Availability: Discontinued

Please note that the Huber + Suhner SL60-4001 has been discontinued. We recommend the Huber + Suhner SL60-4010 as the closest alternative.

Huber + Suhner SENCITY LINK SL60-4001 60 GHz Point-to-Point Ethernet Wireless Bridge

SENCITY ® LINK is designed to work as a point-to-point data link in the 60 GHz unlicensed band. It supports a variety of short range applications up to 800 m (2600 ft). The signal absorption by oxygen and the narrow beam width of the high gain planar antenna allows for high spatial reuse and a high security level.

Benefits

• Easy installation - The concept of the SENCITY ® LINK allows to the end user to install it as easy as any other network component. 
• The single cable solution reduces the complexity of the installation. The radio unit is connected to the network and supplied with power through a single outdoor rated Cat5e Ethernet cable
• The visual alignment tool allows the user to easily install the link. Immediate operation without the need of additional configuration is granted
• Network performance - Guaranteed full duplex 100 Mbps along the complete range. Unlike typical WLAN equipment the user can transmit a full 100 Mbps over the link.
• License free operation - The system has been approved for operation by the FCC and Industry Canada authorities.
• System administration - To monitor the status and the traffic the user can access the link statistics either via the HTML user interface or by integrating it into a network management tool via SNMP.
• Security -  The proprietary radio interface does not allow any other system to access the 60 GHz transmitted data. A high level of data security is inherent in the product via signal absorption by atmospheric oxygen and the use of high gain/narrow beam width antennas

Applications

• LAN extension
• Redundant access
• Campus connectivity
• Disaster recovery
• Wireless backhaul
• Centralization of IT infrastructure
• Temporary connections during events
• Mesh and multipoint networking

System Block Diagram

Technical data

• General system information
• Transmission Capacity: 100 Mbps Full Duplex
• Ethernet frame size: max. 1916 bytes
• Latency:   < 50 µs 
• Range*:  up to 800 m (2600 ft)
• Availability*:  up to 99.999%

*The range depends on the climate zone and the requested availability

Connection

• Interface:  100 Base-TX
• Cable Length:  max. 100 m (300 ft) 
• Signal Wires:  CAT 5e
• Connector:  RJ45 (seal kit included)

Mechanical data

• Dimension:  162 x 162 x 89 mm  (6.4“ x 6.4“ x 3.5“)
• Weight:  2500 g (5.5 lb) terminal 1000 g (2.2 lb) bracket

System administration

• Management:  SNMP (get / trap)
• Web browser-based

Power supply

• Standard:  PoE (IEEE 802.3af)
• Power Consumption: 11 W

Environmental data

ETSI EN 300 019-2-4 T 4.1E for telecommunications equipment non-weather protected locations - extended

Radio Interface

• Frequency:  59.375 / 62.225 GHz (FDD)
• Modulation:  QPSK

Regulatory Compliance

• EN 50371, EN 55022, EN 55024, EN 60950-1, EN 302
• 217-3, EN 302 217-4-2, FCC Part 15, IC RSS210,
• RIR0302-47, BNA Mitteilung 217 /2008

Order Information (link i.e. two terminals)

• SL60-3001 84057630 600 m range*
• SL60-4001 84064720 800 m range*
• * guaranteed minimum range performance measured on the 
• indoor test branch simulating path loss excluding rain attenuation

User Interface

Specifications Tab

Questions Tab